If this project was done with traditional woodworking techniques it would take a while to explain. Luckily I've branched out from traditional woodworking techniques and this was a fairly simple weekend project. The design is done in V-Carve and the execution is done on the OneFinity CNC. There are three carves. The first is with a v-bit and it carves out the lettering. The second is a 1/2 inch round nose to do the juice groove. The third is a 1/4 inch end mill to cut the board out. There is a slight curve to all sides which adds very little complexity except when creating the design. Everything is finished off with bronze epoxy and a mineral oil finish. Material is Sapele.
No comments:
Post a Comment